Thanks for the speedy response! When I type in "points" after "dview"
it says that is an invalid selection. I just started using DR so I am
a complete amateur!

--- In DesktopRadiance@yahoogroups.com, "Evangelos Christakou"
<vangelis@...> wrote:
>
> Hi group!!!
>
> I think the best way to set up a camera view in AutoCAD is the "old
way":
>
> 1- command:DVIEW
> 2-option: POINTS
> 3-option: TARGET POINT: use ".x" (you must type it without " " , to
filter X
> coord) than ".y" (to filter Y coord) than ".z" (to filter Z coord)
> 4-option: CAMERA POINT: use the same above.
>
> so you have a camera with precision, you have to adjust the lens and
after
> that:save this view.
>
> Now in DR menu, you may choose it to render your model.
>
> regards,
>
> evangelos christakou
>
> 2007/7/9, tracy_colcord <tracy_colcord@...>:
> >
> > Hey everyone! I've been having problems setting up the camera in
> > desktop radiance. I can get a very good image of the outside of the
> > room I build but cannot get any views of the inside. When I set up a
> > camera and switch to that view, it just shows the inside of the camera
> > and nothing else. Can anyone help me?!?!
> >
> >
> >
>