Okay sorry all!! I figured the dview command out. However, I still
get exterior views from it. What am I doing wrong?

--- In DesktopRadiance@yahoogroups.com, "tracy_colcord"
<tracy_colcord@...> wrote:
>
> Thanks for the speedy response! When I type in "points" after "dview"
> it says that is an invalid selection. I just started using DR so I am
> a complete amateur!
>
> --- In DesktopRadiance@yahoogroups.com, "Evangelos Christakou"
> <vangelis@> wrote:
> >
> > Hi group!!!
> >
> > I think the best way to set up a camera view in AutoCAD is the "old
> way":
> >
> > 1- command:DVIEW
> > 2-option: POINTS
> > 3-option: TARGET POINT: use ".x" (you must type it without " " , to
> filter X
> > coord) than ".y" (to filter Y coord) than ".z" (to filter Z coord)
> > 4-option: CAMERA POINT: use the same above.
> >
> > so you have a camera with precision, you have to adjust the lens and
> after
> > that:save this view.
> >
> > Now in DR menu, you may choose it to render your model.
> >
> > regards,
> >
> > evangelos christakou
> >
> > 2007/7/9, tracy_colcord <tracy_colcord@>:
> > >
> > > Hey everyone! I've been having problems setting up the camera in
> > > desktop radiance. I can get a very good image of the outside of the
> > > room I build but cannot get any views of the inside. When I set up a
> > > camera and switch to that view, it just shows the inside of the
camera
> > > and nothing else. Can anyone help me?!?!
> > >
> > >
> > >
> >
>