John, Have you forgotten WHY Art is working on the G2002? Parallel ports are vanishing... Hope this helps, Ballendo P.S. Art has said he prefers a "dumb"...
Raul,Bob, I don't see the logic in this choice... Changing to 5TPI reduces the mechanical advantage, which he may need. It also would seem to me that it will...
... Reports of the death of the parallel port are premature. I admit that the parallel port may be dissappearing on the PC motherboard. But I don't think it's...
... Most of us were skeptical of the parallel port at first. There are now perhaps thousands of us using the pport and it has been rare to hear of a fried...
Ballendo: I already ordered the G210. The lead screw it's no binding and it's moving freely. Thank you Raul Lara ... need. ... and ... re- ... confirm, ... ...
By the way Is the G210 installation the same as G201? If not What's the mayor difference? How to change the pulse multipliers? I'm asking this because I...
Bob: I will appreciate if you could do that for me. Thank you Raul Lara ... tried ... time ... and ... 901... ... would ... is ... problem???? ... speed ... ...
The problem is that the ISA and PCI busses are disappearing. Instead, there's the USB or FireWire. There will be "USB to Parallel" ports in the future (to...
Marris: Very elegant. It looks like a great spindle speed control card. I can see where a three stepper, one servo and one IO card would make a complete system...
Tomorrow I will get two G210 from UPS and I had never installed one of this. I'm familiarized with G201 and would like to install the G210 as similar as...
Hi, Mariss: For future designs, it'd be nice if input registers that indicated the settings of any jumpers on the board were made available. It'd be nice, for ...
The jumper settings would usually be a 1 time adjustment and thus don't need monitoring. Once set they normally would not be changed. In the initial design I...
Raul, 1) It is best to have the inputs set to "common +5V" 2) Full Step 3) In "Standby" the current drops to 30% of set value Mariss ... be ... Standby?...
Jerry, I understand that; the problem is the jumper setting signals aren't constant logic levels that can be read back as a "1" or a "0", rather they are high...
Wayne, My plate is pretty full right now. When I get a chance I will generate that data. My guess is it will be much more relaxed because of the nature of the...
... Would like you to consider the following for the servo/spindle card: 1) Quadrature A/B signals input to the card for closing the position loop 2) Output...
Hi, A couple of messages cause me to ask this question: How important is it to have a +/- 10V command output for the servo card? This would require the G2002-B...
hmm, for maybe 65% of us (them..) it wouldn't matter, those with spindles capable of speed control could really use this option. erie ... From: Mariss...
... From my point of view: so long as there is an analog output, I can match whatever you give me to whatever I need. In fact, I probably already have cards...
Dwayne, That being the case, how about having the gain and offset op-amp on the axis card that would become active for the +/- 10V out when you connect +/-...
Hi, Mariss - I can't provide any input to your question, but am wondering whether the USB port that's supplying the 5 volts will be able to handle the...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
