Your request is noted. The G203 layout has been modified to accept a 6mm top-adjust trimpot as well as the current 3/8" side adjust one. The can will have a...
Mariss, has the G100 hit its peak as far as revisions/improvements concerned? I know there had been some little tweaks a while back to help control the twitter...
Just yesterday I had to slip a drinking straw over a long thin screwdriver so that I could go "through" the power supply to reach a back trimpot......Thanks...
Hi Mariss, Can't you use a bicolour LED? Alternatively it may be worth looking into using a light pipe. Several manufacturers offer light pipes in various ...
...and fools never differ ;;-)) What I had in mind is that the endusers can find their own bit of "perspex" rod, (flame?) polish the ends and push it through...
http://www.allowe.com/Humor/audio/HailTheColoRectalSurgeon.wav by http://www.bowserandblue.com/ ... I ... of ... the ... optical quality." ?? ... may I ... ...
A batch of G202's (D6) received about 2 months ago seemed to need very little effort to slide the blue terminal blocks down onto the header pins. (8 drives in...
Went down to the local store and got an equivalent looking set - router is back in production. But, having cut open the offending terminal connector, and seen...
Ron, I have a customer that may have the same problem with a G202. The symptom is, no drive and the LED on the drive is very dim. The current batch of G202 ...
Bob, Just checked, these are E6 batch as well. Luckily it was the terms for the power supply and the drive would just power up and down when I wiggled the...
Ron, Thanks, I do not need these kind of problems with my enclosures. I am about ready to put up all the info for my enclosures on my web page. I do expect to...
This is becoming a growing concern for us. The On-Shore Technology 130-series connector we use had been reliable for the past 5 years. They changed over to an...
Thanks for an extremely thorough reply. Gerald ... reliable ... version ... connector ... series ... when ... force ... contacts ... after ... years. ... well....
Hi, I'm cross-posting this everywhere because I need a lot of replies fast. I'm nearly done with a G201/G210/G202/G212 replacement design called the G203 for...
Hi Mariss, I would think that option 2 is the way to go. A ground common point can be easily found on any CNC system (I think). I can't envisage a system where...
In a message dated 7/5/2006 10:27:02 P.M. Central Daylight Time, mariss92705@... writes: Please let me know: Option (1)<< Jan Rowland [Non-text portions...
Hello, I would prefer option 1, the reason is: the signal to drive the G203 has to be inverted, so a software change is needed, which is not always possible. ...
Mariss, The Sound Logic ( Campbell breakout board ) has a jumper that can be set for COM = +5v or GND so we can handle either way. What are the other features...
I would go with option #1. Some of us old designers have had ACTIVE LOW burned into our brains since we switched from transistors to TTL (no pun intended)....
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
