A week ago Bob Sandy reported apparent disagreement between the elevation obtained at a mobile site using his Kiwi OSD with Garmin GPS 18 and the elevation...
Hello, I am asking this because I am writing a small program for myself that, among other things, reads time from a GPS unit. I wish to know how one can...
Hi Bamm ... Kiwi-OSD uses one extra feature of its GPS module -- its 1 pulse-per-second (PPS) output. The beginning of this pulse is very accurately synced to...
Hi Steve, ... I understand that the Kiwi-OSD only uses the Garmin 18. Is the PPS a unique feature of this unit, or do other receivers have it as well? In ...
Hi Bamm ... Very few hand-held GPS units have a 1PPS output. That's why the Kiwi uses a specific GPS module. Other modules exist, and they could work too, but...
Hello Bamm, Firstly thanks to Steve Russell for his extremely good answers so far - there is not much I can add to your well informed answers Steve. ... It...
Thank you very much Geoff and Steve. Your replies are very informative and helpful, and are enough for me to get started. It's not really a timing project,...
I solved it. Found by trial and error and comparison with other timing devices that, at least in my unit, the NMEA record always get sent out at the turn of...
Hi Group, I placed an order for a KIWI last week but have a couple of questions. Most laptops no longer have DB9 serial interfaces. These have been replaced...
Hank, yes, you could have asked me some of these questions as they are not technical in nature. regarding the garmin 18 vs the 18x: garmin is offering both...
who remembers the name of the software (and where is it available) that will capture GPS data and plot scatter diagrams of the location data points? if i had...
Hi Vince, Do you mean Visual GPS? or was that virtual. I think Kiwi Geoff wrote it. I have that somewhere on my laptop and can forward it to you if you like....
When I video record partial lunar eclipse on August 16. after about 2 hours recording I notice the Kiwi OSD time display seems few minutes behind. I press the...
I direct you to: http://www.geocities.com/kiwi_36_nz/kiwi_osd/kiwi_osd.htm where there is a write up about this situation. if the "ERROR: USE FIELD COUNT" is...
Mr W. C. Yue wrote ... Thank you for describing the situation so carefully - I think we can isolate the fault quite well for you. After KIWI OSD starts time...
Dear Geoff, Thank you for your reply. The problem is I turned off the video camera several times during lunar eclipse for more than 256 sec. It is not the...
I use the LOW 4.0 software to alert the next coming occultation event during lunar eclipse and found out the computer time clock (sync with time signal) was...
Hi Vince, I got my new Kiwi and the first power up I had my old Garmin plugged into it because it was right there. The screen stayed "missing rs232 or 1pps" or...
Steve, i'll contact you offline about this. it is probably a firmware issue, but resetting the configuration is a stopgap solution. did you verify (using a...
Hi Everybody ! I am a new user of Kiwi OSD version 41. I would need help using this VTI. First of all, I use a WATEC120N PAL as electronic detector and SONY...
Mr. Delmotte, This is Vince, the owner of PFD Systems. How did you acquire the OSD unit? i searched my sales records and could not find your name listed. Did...
Vince, Thanks a lot for your fast reply :-) ! I bought my OSD in MecAstronic (www.mecastronic.com), a french dealor of amateur astronomy devices. I think...
Bonjour Xavier, ... Yes, it is interesting to view the page: http://www.mecastronic.com/video_datation.htm ... That is the correct GPS to use. However if you...
Xavier, Could i ask you to join the group? it is easier to post your messages as i don't have to authorize them each time you post. as for your question... try...
Vince,
> Could i ask you to join the group? it is easier to post your messages
> as i don't have to authorize them each time you post.
Ok I thought I have...
Xavier, I just checked and you are already a member of the group, so you don't need to apply again. your messages are being moderated for some reason. are you...
Hi Everybody ! Early this morning, I modified a parameter in my serial port and I could transfer data from my pc to the gps. And then, I test the OSD connected...
... I'm pleased to hear that you finally got to communicate with the GPS18 with your computer Xavier. ... Yes, this proves to me that your wiring and the GPS...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
